5.2 Cleaning the filter silencer (part-2)


5.2.2 Removing / installing the cleaning line

 
1
Injection pipe
2
Pipe
3
Guide tube

Removing the cleaning line

·        Disconnect the line (2) at the injection pipe (1) and remove the screw coupling from the pipe.
·        Withdraw the pipe (2) from the guide tube (3).

                               Punch out the guide tube



·         Punch the guide tube (3) out of the caulking with a bolt (diameter = 16 mm) and withdraw it.
 
NOTE

Heavily soiled components of the cleaning line must be replaced with original parts from ABB Turbo Systems.
Installing the cleaning line


·         After fitting the slide-in modules (E), re-fit the guide tube (3) and recaulks it.
·         Fit the pipe (2) and screw to the injection pipe (1).


          1. Purpose of the manual
          2. Layout and function
          3. Correct use of the turbocharger
          4. Essential information
          5. Abbreviations and symbols
          6. Turbocharger rating plate
          1. Basic safety instructions
          2. General safety instructions
          3. Special safety instructions
          4. Safety instructions and hazard protection
          5. Warnings on the turbocharger
          1. Oil supply
          2. Inspection work
          3. Putting into operation after laying up
          1. Servicing work
          2. Monitoring
          3. Emergency mode TPL..VA
          4. Surging of turbocharger
          5. Contact with rotating parts
          6. Shutting the engine down
          1. Foreword to MaintenanceServicing work
          2. Cleaning the filter silencer
          3. Cleaning the compressor during operation
          4. Cleaning turbines and guide blades in operation
          1. Possible remedies for failures
          1. Turbocharger weights
          2. Remove the turbocharger
          3. Installing the turbocharger
          1. Module weights
          2. Remove filter silencer/air suction branch and compressor casing
          3. Removing cartridge group
          4. Axial clearance
          5. Disassembling and assembling the turbine diffuser
          6. Dismantle the VTG unit together with the gas inlet casing
          7. Installing the VTG unit and gas inlet casing
          8. Installing the cartridge group
          9. Install filter silencer/air suction branch and compressor casing
          10. Table of tightening torques
          1. Possibilities for emergency repair
          2. Fitting the cover plate
          3. Blocking the inlets and outlets
          4. Bypass the turbocharger
          1. Taking out of operation for up to 12 months
          2. Taking out of operation for more than 12 months
          1. Ordering spare parts
          2. Directory of part numbers
          3. General view of turbocharger
          4. General view of cartridge group
          5. General view of VTG unit


Share on Google Plus

About shaikat

This is a short description in the author block about the author. You edit it by entering text in the "Biographical Info" field in the user admin panel.
    Blogger Comment
    Facebook Comment

0 comments:

Post a Comment

Related Posts Plugin for WordPress, Blogger...

Featured Post

PID CONTROLLER 3-WAY TEMPERATURE CONTROL VALVE

A proportional-integral-derivative controller ( PID controller ) is a control loop feedback mechanism used in power and industrial con...

RECENT POSTS

Recent Posts Widget